![]() ![]() Splash=silent resume=/dev/system/swap mitigations=auto quietĭesktop: N/A dm: SDDM Distro: openSUSE Tumbleweed 20230216ĭevice-1: AMD Navi 10 vendor: Gigabyteĭriver: amdgpu v: kernel arch: RDNA-1 code: Navi process: TSMC n7 (7nm) built: 2019-20 pcie: ![]() Parameters: BOOT_IMAGE=/boot/vmlinuz-6.1.12-1-default root=/dev/mapper/system-root pci=nommconf ![]() amdgpu.dc=0 - screen stays on, but shows nothing (just black).remove “quiet”, remove “splash=silent”, and append “plymouth.enable=0” (as written at SDB:nomodeset: Work Around Graphic Upgrade & Installation Obstacles - openSUSE Wiki) - nothing changed.(WW) AMDGPU(0): Unable to find connected outputs It doesn’t matter if it’s my Tumbleweed or a Leap 15.4 booted from usb stick.Īmdgpu 0000:09:00.0: Cannot find any crtc or sizes It doesn’t matter if I boot my Tumbleweed with current or previous kernel. But if I start my Tumbleweed with amdgpu drivers, then as soon as kernel loads drm driver (so it’s even before Xorg starts), the screen goes blank (the monitor shows “no signal” and shuts off).If I put my card into another computer with Windows, it works with acceleration, like there’s nothing wrong.It’s not a faulty monitor, because I use it also with my laptop on a second input.I usually use HDMI cable, but with DisplayPort it’s the same. It’s not a faulty cable, because I tested it with other cables.If I run the system with “nomodeset” kernel option, then there is video output (obviously without acceleration and limited to low resolution).At BIOS and GRUB there is video output.Few days ago my Radeon RX 5700 after 3 years of working absolutely fine, kind of stopped working. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |